Step 2:
Grate the Fels Naptha- the easiest way to do this is to cut it into several smaller chunks and then run it through a food processor- otherwise, you can just grate it with a hand grater or shave it with a knife.
Step 3:
Add the freshly grated soap to the water in the saucepan, stirring almost constantly. Reduce the heat to medium, It will take approximately 10 – 15 minutes for the Fels Naptha to complete dissolve. If it takes longer, your heat wasn’t up high enough. Alternatively, you can melt the fels on the stove over low heat without water then add the water afterwards, stirring it in, as the original recipe called for. I find that it’s much easier to melt IN the water. Absolutely do NOT let this Boil over, or you’ll have a sudsy mess that you do NOT want to contend with!!
It should be a rolling, simmering boil where you must stir Constantly but it does not foam heavily or seem to “creep up” the saucepan. See the photo below- note the amount of “foam” – that’s all you should see.
Step 4:
Once the Fels Naptha has completely melted, remove the pan from the heat and add in the Borax and the Washing Soda, stirring constantly until the powders are completely dissolved, this will take about 3-5 minutes. Do not under-stir or your soap texture will be very grainy rather than smooth. (You can fee the “graininess” on the bottom of the pan, once you can’t feel it, it’s incorporated fully!)
Step 5:
Pour the liquid equally into (2) 1 quart Mason jars.
Step 6:
Add just enough water to bring the contents up to the “shoulders” or Rounded part of the jar, leaving approximately 1 ½ inches of headspace.
Step 7:
Please Head On Over To Next Page Or Open button (>) To Continue Reading and don’t forget to SHARE with your Facebook friends
GIPHY App Key not set. Please check settings